Attach Countertop To Cabinet

Predrill a screw hole through the mounting blocks but be very careful not to drill or drive the screws so deeply that you break through the finish surface.

Attach countertop to cabinet.

Place pressure sticks every 12 to 18 inches to help the adhesive bond the. A continuous bead of caulk fills this varying gap. Given less than perfect cabinet installs and the fact that the back side of the stone is not perfectly flat there can be a varying gap between the stone and wood. This is to create a surface that you can attach your butcher block countertop to.

Use a belt sander to sand the backsplash to the line drawn with the compass. Install the blocking flush with your cabinet tops by first drilling pilot holes at an angle through the blocking and then screwing the blocking to your cabinets. Place the countertop on the cabinet and ensure the backsplash is flush against the wall. Remove the countertop and clamp it in place on sawhorses.

Remove the corner bolts and screws from underneath the countertop holding it down to the. Apply a bead of silicone caulk or construction adhesive along the top edge of all the cabinet parts that support the. Attach the countertop by driving р 4 in long screws up through the 1x mounting blocks installed by the cabinet manufacturer see the illustration on the fac ing page. Set the sink back far enough to clear the cabinet front.

It must seal and bond very well while supporting the weight of the full sink. Now place countertop on cabinet again to double check placement of sticks and that the countertop is tight to the wall. We install countertops with a continuous bead of 100 silicone caulk along all the exposed joints between the stone and the cabinets. Place countertop on sticks and push firmly to wall.

Lower the countertop back into place or remove the shims. These screw clamps will allow the countertop to. Remove the disposal and drain trap and disconnect the water supply and drain lines to the area. You can get into trouble here if you don t think through three important steps.

Remove countertop and apply panel adhesive to sticks fig 4 taking care not to use so much that squeeze out drips on cabinets. An undermount vanity sink requires a very special adhesive. Tighten down the block from inside the cabinet drive a deck screw fitted with a fender washer up through each hole into the butcher block. It is very important to seal the sink properly to the counter top because if the supports weaken and the sink separates from the counter water will leak into your cabinets.

Cut the hole smaller than your sink s rim. Center the sink over the sink base cabinet. Use a quality grade of 3 4 plywood or 1x stock boards to do this. Position the countertop pieces on the cabinets.