Attach Countertop To Cabinets

Start by applying a 2 to 3 inch 5 1 to 7 6 cm thick bead of adhesive to a corner and then working your way around the top of each cabinet.

Attach countertop to cabinets.

You can get into trouble here if you don t think through three important steps. We install countertops with a continuous bead of 100 silicone caulk along all the exposed joints between the stone and the cabinets. With build up strips secured to the bottom of countertop you can now place the countertop back on the cabinets. Cut the hole smaller than your sink s rim.

Center the sink over the sink base cabinet. Apply a bead of silicone caulk or construction adhesive along the top edge of all the cabinet parts that support the. Lower the countertop back into place or remove the shims. Apply silicone adhesive beads to the top of the cabinets.

Space each bead apart by 6 to 12 inches 15 to 30 cm to make sure that the silicone holds the counter as securely as possible. Take off the sink brackets and pull out. Predrill a screw hole through the mounting blocks but be very careful not to drill or drive the screws so deeply that you break through the finish surface. Given less than perfect cabinet installs and the fact that the back side of the stone is not perfectly flat there can be a varying gap between the stone and wood.

Position the countertop pieces on the cabinets. Place the countertop on the cabinet and ensure the backsplash is flush against the wall. Install the blocking flush with your cabinet tops by first drilling pilot holes at an angle through the blocking and then screwing the blocking to your cabinets. Use a belt sander to sand the backsplash to the line drawn with the compass.

Cut the sealant along the backsplash. Attach the countertop by driving р 4 in long screws up through the 1x mounting blocks installed by the cabinet manufacturer see the illustration on the fac ing page. This is to create a surface that you can attach your butcher block countertop to. Place pressure sticks every 12 to 18 inches to help the adhesive bond the.

Set the sink back far enough to clear the cabinet front. Use a quality grade of 3 4 plywood or 1x stock boards to do this. Remove the disposal and drain trap and disconnect the water supply and drain lines to the area. Remove the corner bolts and screws from underneath the countertop holding it down to the.