Attaching Vinyl Siding To Concrete

In effect i would need to add a bit of spacing between the concrete and the siding.

Attaching vinyl siding to concrete.

Using self tapping screws such as those by tapcon will fasten the strips to the concrete securely but concrete nails can be used as well. The vinyl siding that around the concrete portion that i want to cover up is attached to an osb board that s attached to the framing of the house. Insert sleeve anchors then attach other furring strips as you did with the first one and tighten the sleeve anchors. How to install siding on concrete block house.

Snap a horizontal line at the lowest point on your garage wall. The number of strips you need. Step 3 attach a vinyl panel starter strip. It slips into the groove between adjoining slats and once it clicks into place you can hang items as heavy as 12 pounds.

The concrete foundation is nearly flush with the first floor siding meaning that using furring strips would cause the new siding to stick out. Install the boards horizontally placing them flat against the. Measure the width of one block wall and cut treated two by fours to match. Then slide the tool horizontally along the lock to release it.

The contractor proposed using tapcons to attach the siding directly to the foundation which would allow the siding to line up with the first floor. Another poster mentioned remington rounds for fastening. For attaching something relatively light to concrete it s hard to beat the speed and ease of hammer set anchors each anchor consists of an unthreaded pin set into a metal sleeve. Draw a line on the wall along the top of each siding course before you pull the nails.

I d like to attach the siding directly to the concrete here. With the furring strip lined up with the other holes drill holes in the strip to match those in the wall. Install a strip of insect netting along the bottom edge of the concrete wall by nailing the. As a result the osb protrudes about a half inch farther out than the concrete.

Installing 2 inch wide treated strips is necessary for a solid base for the house siding. Attach the boards to the block by holding them in position you ll need an assistant and drilling through the boards and the. The strips can be ripped from 2 inch by 4 inch lumber or plywood but they should be at least 3 4 inch thick. Nail 1 1 2 inch thick wooden furring strips to the concrete wall at 4 foot intervals using concrete nails.

Lift the unlocked siding to expose the nailing hem of the siding piece below. Slide the zip tool under the butt edge of the siding hook the locking edge and pull down. The easiest and safest way to hang something from vinyl siding is to use a siding hook.