Attic Stairs Trimming Bottom Section To Length

Built for safety this sturdy wood ladder makes it easy to access your attic with nine non slip steps and a convenient handrail for support while climbing.

Attic stairs trimming bottom section to length.

The werner wood universal fit attic ladder features the werner wood universal fit attic ladder features a 250 lb. Use a straightedge and a tape measure to measure the length needed for the bottom section measuring at both sides of each ladder rail to find the angle for the bottom ends of the rails. Each section of the ladder has 2 different positions to catch onto the other section so you might need to experiment to find the best height for your attic. Install rubber tread to bottom ends of rail using 1 screws provided.

9 trim them again. Mark and cut the bottom section of the ladder cutting the rails at an angle to match the floor. Fold the bottom section of ladder out of the way. Transfer cut length dimensions from table 4 to the bottom section of the ladder right and left rails and draw a cutting line between the two points.

The bottom section of the stairs should fit flush with the floor on both sides after cutting. Trim bottom section to length using wood saw. Step 5 check to make sure the stairs fit flush with the floor and that all joints are tight with no gaps fig. Trim bottom section to length using a metal cutting saw figure 7.

Press down on the climbing section to insure that the power arms are fully extended. Rotate bottom section back in line with top sections and press down on the middle section to ensure that the power arms. Photo by kolin smith where to find it. During the installation process depending on your floor to floor height you might have needed to install additional stops.

Drill 1 16 pilot holes. Do not use the folding attic ladder. Metal folding stair model 2200 werner co. Nail the trim into the door jamb of the attic stairs by driving the 4d nails through the bottom of the trim where it is thinner it should make contact with the jamb frame of the attic stairs.

If the stairs are too long fig. Weight capacity designed to fit ceiling heights from 8 ft. Greenville pa 724. Trimming bottom section to length see figure 5.

Push down on the top and second joints to make sure the stairs are extended properly. Don t nail into the ceiling joists just yet that steps comes last once all four pieces have been loosely installed. Pull down the folding attic stairs. D transfer these dimensions to the bottom section of the ladders right and left rails and draw a cutting line between the two points.

Fold open the top two sections but keep the final section folded up. Step 4 cut each bottom stringer to the proper length along the lines drawn.